Dodge RamCharger Central banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3,136 Posts
Discussion Starter · #1 ·
ok i found a good drivers door at the junkyard and i'm going to get it on tuesday if all goes well. the thing is its on a one ton truck and it had the big mirrors that bolted above the window as well as below. what would be the best way to patch these holes?
 

·
Registered
Joined
·
30,125 Posts
tack weld some sheet metal in [metal inside weld outside] grind smooth and fill
 

·
Registered
Joined
·
7,749 Posts
you could always go with the cheapo jockey lot paint job and just but a bolt in the hole and paint over it. A carraige bolt may be best.

But seriously, what booger35 said would be much better.

What I wonder is, there's another thread somewhere about that seam bonding goop that many factories are using instead of full welds anymore. Wonder how that would work (with the sheet metal backing still).
 
1 - 3 of 3 Posts
Top