Dodge RamCharger Central banner
Cancel

U-Bolts on rear yoke

1468 Views 9 Replies 6 Participants Last post by  Andrew K, 
A
I now have a D60 rear axle in my '83 RC, and every time I take it out in the mud the bolts in the u-joint straps snap off the first time I get on it. Can I drill out the holes and use u-blolts? I have always heard not to but I can't think of any problems this would cause, but I am sure I am overlooking something, does anyone know the answer? Also I am using a full-time 3/4 ton D44 in the front right now, and I have a 3/4 ton 44 w/ lockouts sitting at the shop, but the gears are out of it. I am in the process of putting in axle joints right now and was thinking that this would be a good time to switch to lockouts and was wondering what all I would have to switch out. I guess what I need to know what I need to know is do I need to put the new axle joints in the full-time axles or will I need to switch the outer stub shaft?

Thanks
Reply
Save
Like
1 - 1 of 10 Posts
M
this may or my not help but i just found this out myself and its make sence
make sure that the u-joints are in a straight line i normally just set the shaft on the ground to check and see
Reply
Save
Like
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Dodge RamCharger Central
RamchargerCentral.Com is a Dodge truck community built by a vast number of experienced owners. Whatever you're thinking about doing from routine maintenance to full-on restoration, odds are somebody around here already has. Originally focused on the Ram Charger / Trail Duster, our members own, drive and wrench on Mopars from the 40s to the current day. It's not what you buy, it's what you build.
Full Forum Listing
Explore Our Forums
Vehicle Help Open Discussions Technical Discussion Ramchargers, Traildusters, Durangos and other SUVs Rams, Power Wagons, D/W 50s, Dakotas and other tru
Top