Dodge RamCharger Central banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Founder
Joined
·
9,934 Posts
Discussion Starter · #1 ·
These are the torque specs for the inner and outer locknuts on a CAD equipped Dana 44.

These were submitted by bill2e

Tighten the inner locknut to 50 ft. lbs. to seat the bearing. Loosen the inner locknut, and retighten to 30-40 ft. lbs. while rotating the hub. Then back off the inner locknut 135 degrees. Outer locknut is tightened to 50 ft. lbs.

The inner locknut will be loose enough to remove by hand after it is backed off properly.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top