Dodge RamCharger Central banner
1 - 4 of 4 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
Anyone know where I can find a temperature sender wire pigtail for 1989 ramcharger 5.9 tbi
 

·
Registered
Joined
·
13,500 Posts
NAPA ? there are 2 temp gizmo's , one with 2 wires ( sensor for pcm )    one with 1 wire ( sender for gauge )
 

·
Registered
Joined
·
31 Posts
If it is a male barrel connector you could just use a 10-12ga butt splice to lightly "crimp" onto the sender's male side.  If it is a spade connector type any off the shelf male or female spade connector should do.  For my 83 the sender is just a male barrel connecter so i used the butt splice to carefully "crimp" it to the sender. FWIW that seems to be the easiest option.  A little heat shrink over the connector when done goes a long way.
 

·
Registered
Joined
·
232 Posts
For the single pole sending unit this is the correct connector. They are called "bullet connectors". The female connector.

 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top