Seems like it might be a u joint is shot or the tranny mounts are gone . If you swap in the 727 u cna use the 241 but u need to use the old drive shaft cuz the old one will be about 4" too short .
Shuddering and shaking on 90 RC
My 90 shakes and shudders pretty bad. It seems like it's originating in the tranny.(A-51
. I know for certain it's not steering or driveline related. In addition to shuddering and shaking, there's quite a bit of slop in the tranny/transfer case, it clunks when I let off the gas and then push it again, and also, there is an occasional scaping/grating sound. It does this with the OD off or on, in all gears.
I guess I know what my problem is (tranny...duh!) but I was wondering if anyone had any input as to what the problem may be or any similar symptoms in the past. Something as simple as an output bearing maybe?
I have a 727 sitting in my garage that I just took out of my 84 so I think I'll put that in. I have a question. Will the 241 mate up to the 727 or do I need to use the 208?
Thanks,
Ted
. I know for certain it's not steering or driveline related. In addition to shuddering and shaking, there's quite a bit of slop in the tranny/transfer case, it clunks when I let off the gas and then push it again, and also, there is an occasional scaping/grating sound. It does this with the OD off or on, in all gears. I guess I know what my problem is (tranny...duh!) but I was wondering if anyone had any input as to what the problem may be or any similar symptoms in the past. Something as simple as an output bearing maybe?
I have a 727 sitting in my garage that I just took out of my 84 so I think I'll put that in. I have a question. Will the 241 mate up to the 727 or do I need to use the 208?
Thanks,
Ted
1 - 2 of 14 Posts
1 - 2 of 14 Posts
