Dodge RamCharger Central banner

Remove wiper knob

2K views 2 replies 2 participants last post by  Paychk 
I dont know for sure either but if you are looking at the instructions below..it almost sounds like it unscews off the end of the shaft?

Disconnect negative battery cable.
Remove steering column cover, then the steering wheel pad from steering wheel.
Disconnect horn electrical connector from horn pad.
Remove steering wheel nut, then then steering wheel using suitable puller.
Pry wiring trough from steering column, then remove wiring from trough.
Using lock plate compressor tool No. C-4156, depress lock plate and remove retaining ring.
Remove lock plate, cancelling cam and upper bearing spring.
Remove switch stalk actuator screw and arm.
Remove hazard warning switch knob.
Remove turn signal switch attaching screws, then the switch.
Remove ignition key lamp, then the lock cylinder.
Remove buzzer switch by pulling straight out of housing. Do not allow spring to fall into column.
Remove three housing cover screws and housing cover.
Press wipe/wash pivot pin out using a suitable punch.
Remove wipe/wash switch assembly.
Pull the hider up the control stalk, then remove stalk to switch attaching screws.
Remove wipe/wash switch control knob from end of stalk, then rotate control stalk to full clockwise position and remove stalk.
Reverse procedure to install. Torque steering wheel nut to 45 ft. lbs.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top