[mike_wiz]

I would not put this up here but I just had surgery so I am confined to the couch and labtop for a while.

I just put a shakle flip on my RC and did not replace the rear leaf spring bushings. Well it turns out I have an add a leaf that is in the rear and I am going to take it out and when I do I am going to replace these bushings.

The parts store says there is two sizes 1" or 1 1/4"? The bolt thru these if I remember is pretty big so I think it is the 1 1/4".
Thanks

Mike

 

[Lurker]

The bolts on mine aren't that big. I'm using a 13/16 inch wrench on one side, and I think 15/16 on the other. Looks like a 1/2" bolt hole size. Yeah, the bushing hole size is 1 inch for mine.
You can get energy suspension polyurethane bushings for around $20. One set is enough to do the rear springs, but not the shackle bushing. The number on my box is 5.2102G. I think that "G" means the colour, which is black.

I did notice that the metal bushings on the energy suspension setup were smaller in diameter than the stock metal bushings on the leaf springs, so smaller bolt diameter will be needed as well.