Dodge RamCharger Central banner
1 - 8 of 8 Posts

·
Registered
Joined
·
134 Posts
Discussion Starter · #1 ·
ok guys, 74 W100 with I believe only factory lift. if i put on one of the RCC shackle flip kits front and rear (which gives a 4" lift) should i need to do anything about pinion angle or the drivetrain? has anyone else used this lift?
 

·
Premium Member
Joined
·
2,631 Posts
I haven't used it, but iirc if the truck is stock height and you use this lift, there should be no problem...

derek
 

·
Registered
Joined
·
8,924 Posts
I just got done doing this lift, with 4 inches the only thing you will need to change is your steering and bigger tires of course! you can change you steering by either getting a drop pitman arm or a raised steering arm. I would suggest the dropped pitman arm because its a hellova lot easier and cheaper to replace than the steering arm.
 

·
Registered
Joined
·
8,924 Posts
intenseimages said:
i didnt need to do any adjustments on the steering or pinion angle after i did mine

eric
Well of course you don't need too, but I bet you also can't turn as tight in one direction as you can the other either...
 

·
Premium Member
Joined
·
17,219 Posts
Dodge 85 RC said:
intenseimages said:
i didnt need to do any adjustments on the steering or pinion angle after i did mine

eric
Well of course you don't need too, but I bet you also can't turn as tight in one direction as you can the other either...
actually that is a bet you would lose, steering never changed after i did my lift

eric
 
1 - 8 of 8 Posts
Top