Dodge RamCharger Central banner
1 - 5 of 5 Posts

·
Vendor
Joined
·
11,798 Posts
Discussion Starter · #1 ·
This is a new Ramcharger Rear cross member made out of 3/16" thick steel. It was patterned from a 1988 rear cross member.

These are made out of 3/16" steel & they bolt into the OEM rivet holes & have the OEM gas tank holes.
They also have the skid plate holes.

If you need a new one or any of you pickup guys putting a RC gas tank in here they are.
Cost is $118.40
 

Attachments

·
Registered
Joined
·
758 Posts
PM sent!
 

·
Registered
Joined
·
758 Posts
Dunno if anyone has asked for the other "half", or the hanger that the front of the RC tank bolts on to?
 

·
Registered
Joined
·
758 Posts
K, I *THINK* I can make it out of angle iron - it looks like all it does is hold the tank straps.  Let me know if you think I'm crazy.  ;D ;D ;D
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top