Dodge RamCharger Central banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
232 Posts
Discussion Starter · #1 ·
Hello everybody.

When I put my truck in 4HI, it pulls heavy to the left on acceleration and if I release the gas pedal, the truck jerks back to the right. If I do the same in 2 wheel drive, the truck performs normally. Any ideas what might cause this problem.
My T-case to crossmember bushings are shot. Would this cause the problem?
 

·
Premium Member
Joined
·
8,998 Posts
sounds like only that side of the front is gettign power......might be time to rebuild the auburn unit in it..or replaxe the axle cuz the splines are gone.
 

·
Premium Member
Joined
·
232 Posts
Discussion Starter · #3 ·
TheRamChargerMan said:
sounds like only that side of the front is gettign power......might be time to rebuild the auburn unit in it..or replaxe the axle cuz the splines are gone.
I thought that at first, but I checked it . The front axle is working fine.
 

·
Premium Member
Joined
·
8,998 Posts
if yer getting torque steer like that, something is wrong.....it may be inside the auburn unit, opr maybe a hub that's not working right.

There's no way to check if it's working right by looking at it or turning it by hand. It would have to be under load to see the problem.

Kinda like a starter that spins freely on the test stand, but won't turn the engine over.

 
1 - 4 of 4 Posts
Top