Dodge RamCharger Central banner
1 - 8 of 8 Posts

·
Premium Member
Joined
·
2,688 Posts
Discussion Starter · #1 ·
Hey Yall. Somewhere before on here, I saw somebody post the part # for a pilot bushing for a 360 crankshaft that was not finish honed for the manual tranny input shaft.

ANy body know what I is talking 'bout?

thanks,
Ian
 

·
Premium Member
Joined
·
26,070 Posts
Nope and why would you want that anyway?

How about a roller bearing instead of the bushing
 

·
Registered
Joined
·
105 Posts
Yea i know what you talkin about. They fit in the crank shaft hub. They can be used for cranks that are not drill or drilled for a pilot bushing. If it's not drilled you may have to shorten your imput shaft...ouch. I have an extra non roller and the only part # I see is 04338876
 

·
Premium Member
Joined
·
2,688 Posts
Discussion Starter · #5 ·
Sweet, that's what I was after. Thank you, you're Highness.

Didnt know I had to hack the input shaft...
 

·
Premium Member
Joined
·
2,688 Posts
Discussion Starter · #7 ·
Ya, I talked to a machinist that told me that they drilled some, but left .025" unfinished... why go half way?

If I do have to shorten the input, I think I will leave that up to a properly equipped machinist.
 
1 - 8 of 8 Posts
Top