Dodge RamCharger Central banner
1 - 12 of 12 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I need a set of gears for a frontend Dana 44 axle. The ratio for the gears is 3.53, anyone know where I can locate these? The truck is a full time 4x4 78 RamCharger with a 440 big block. If someone needs more details let me know, I want to get my baby back and running after her 8 years of beauty sleep!
 

· Registered
Joined
·
5,227 Posts
I have a complete front end with aftermarket axels, new bearings seals and 1" wheel studs. I used this on a tough truch challenge vehicle we had. It has the gears you want. I'm in Houston Texas. I can bring them to RamJam if that might help
 

· Registered
Joined
·
156 Posts
I got a soock front end with the gears you need that I need to getrid of as well
ken
 

· Registered
Joined
·
213 Posts
I've got 3.55's for both a Dana 44F and 9.25 that are Dodge OEM Gears in absolute mint condition. Can sell them cheap. Both sets $90.00 + shipping and handling. I've also got new Timken bearings for the front rear, (44F), (bearings and races), and ring gear bolts that I'll throw in too.

Dave
 

· Registered
Joined
·
156 Posts
charger i got the complete front axel that I am getting ready to switch to 4.56 in it so I dont have to have my truck down for the swap after that I dont know how about 50.00 and you pay the shipping ?? or let me know what you think is fair as for a pic give me a day and I will pull the cover off and send you a pic
 

· Administrator
Joined
·
29,536 Posts
I get the feeling he was a newbee scammer, I sent him packing.
 

· Registered
Joined
·
539 Posts
I get the feeling he was a newbee scammer, I sent him packing.
Sucks, I don't post in the wanted forum because I end up with about 5 of those for every post. Every one of them is a new account with zero posts, all scammers.

It's hard to get help from our own community due to these ass hats.
 
1 - 12 of 12 Posts
Top