Dodge RamCharger Central banner

My 84 W150 *2 new pictures w/33s*

3622 Views 12 Replies 7 Participants Last post by  ChrisLib


No lift, 32x11.50s, 15x10 American Racing Outlaw II wheels. No rubbing, but it is very very close. I am going to be replacing the 32x11.50s with 33x12.50s and trimming the fenders to fit.

There are some other things I want to do/fix, but that will happen in time.

Eric
See less See more
1 - 13 of 13 Posts
man, that is a sweet truck! i allways like the white ones. those rims look great on her!
hehe, Its actually primer tan. Doesn't look half bad though. It used to be red. I bought it primered. Someday I'll probably repaint it in the original red.

Eric
pls leave the fenders and wheels like they are this rig rocks like it is!!!! i love it!!! perhaps a lil bit of lift but nothing else PLEAAAASEEEE 8)
2
No lift, 33x12.50-15 Mickey Thompson Radial MTX on 15x10" American Racing Outlaw II wheels.




:)
See less See more
Ahh, lookin good man. almost as good as when you drove it past be a few days ago ;D

Garrett
Hick said:
Ahh, lookin good man. almost as good as when you drove it past be a few days ago ;D

Garrett
Ha, I didn't even notice you. I was probably jamming to Chevelle and not paying attention. ;D
Prob more along the lines that, i was walking on the sidewalk, and you were driving by. ;)

New tires look damn good though. Soo much better than those old ones you were running around on.

Garrett
That is a great looking truck! I'm jealous of you California guys who don't have to worry about rust. BTW, how much backspacing do your rims have?

Shawn
redneckRC said:
BTW, how much backspacing do your rims have?
That I don't know. Maybe I'll take them off one of the days and measure it. I bought the wheels used.

Eric
I figured you might want a new Profile Pic with the new rims and tires.....here ya go ;D Sweet lookin {cool}




Randall

Attachments

See less See more
cool, thanks! ;D
Nice!!
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top