Dodge RamCharger Central banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Im new to this board. I need some help finding a manifold that will work with my heads. I was going to put an Edelbrock performer carb on but their tech department said the manifold only works with heads up until 86. something about the porting. Iam no gearhead, so i need help. Any companies that make intake? what about the factory 4 barrel intake manifold? any suggestions greatly appreciated.
 

·
Registered
Joined
·
8,924 Posts
The factory 4bbl intake is the best bang for the buck. I've seen them at the J/Y for $25. Then all you need is a carb, and the kickdown linkage from a 4bbl and youre set.
 
G

·
There was no "factory" 4 bbl 318 intake, per se. Rather, there were 318's with 360 4 bbl intake and 360 heads. There's where the difference in the ports lies. The 360 ports are considerably larger, as well as the valves. The Edelbrock Performer intake comes in two flavors...2176 for non-EGR, and 3776 for EGR. They fit 318's through 1991.
 
1 - 3 of 3 Posts
Top