Dodge RamCharger Central banner
Status
Not open for further replies.
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
Help!!!!I'm having major problems lining up my belts x3 on my new 360. The inside pully of my double pullied water pump lines up w/ the outside pully of my triple engine drive pully The alt double pully outside lines up w/ the inside most triple engine drive pully. I am thinking an offset pully for my water pump + shims under the alt or the mounting bracket will solve this?????????? Any ideaas??? The block(360) is 75, the w/pump is off 86 ,318 the trk is an 86 along w/ everthing else. need help motor heads
 

·
Premium Member
Joined
·
26,070 Posts
Ok i am guessing you pulled your 18 out and put in a 60, now if i got that right what you need to do is take everything as far as pulleys go from the 18 and put them on the 60 , so take the crank pulley and water pump pulley from the 18 and put it on the 60, then take all the 18 accessories like steering pump and alt and it's brackets and bolt it onto the 60 also, have fun you'll be done in about an hour
 
G

·
Discussion Starter · #3 ·
Dude I was getting so stressed...Had I stopped and thunk for more time then it took to throw that wrench into the woods I would have figured it out and still had that 1/2 in wrench. Thanks for your help. Hey you got a 1/2 in I could borrow?

Evildriver-3 said:
Ok i am guessing you pulled your 18 out and put in a 60, now if i got that right what you need to do is take everything as far as pulleys go from the 18 and put them on the 60 , so take the crank pulley and water pump pulley from the 18 and put it on the 60, then take all the 18 accessories like steering pump and alt and it's brackets and bolt it onto the 60 also, have fun you'll be done in about an hour
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top