Dodge RamCharger Central banner
1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
How do i get the axle shaft out to get at the U-joints? i have the bearings out now but it looks a retaining ring our seal on the inside needs to come out some how for it to slide out. Or do i have take out the whole knuckle?
Any help would be appreciated.
Thanks Victor
 

·
Administrator
Joined
·
62,277 Posts
You have to take the brake adapter (assembly the caliper mounts to) off. Then just yank on the axle shaft, and it will dislodge the inner seal, and all come right out. Also, the knuckles need to be in the straight ahead position.
 

·
Registered
Joined
·
31,877 Posts
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top