Dodge RamCharger Central banner
1 - 2 of 2 Posts

·
Registered
Joined
·
368 Posts
Discussion Starter · #1 ·
Did manual transmissions only have one brace from the block to the bell?  I’m swapping a 89 w150 NP435 into my rc.  The bracket is present on the pass side but not on the drivers side.  There is not a hole drilled for it on the drivers side bell. There is a boss in the Aluminium bell similar to the one on the pass side but no hole for a bolt. There’s no evidence it has ever been messed with.  Even the dust cover doesn’t have a hole where the brace would fit on the bell.  Just wondering if this was normal for a 89 hydraulic clutch bell.
 

·
Super Moderator
Joined
·
29,799 Posts
The manual only lists one:

4295994 1 D 1,2,3,5,6,7 STRUT, Case to Cyl. Block, Right, All Engines
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top