Dodge RamCharger Central banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,550 Posts
Discussion Starter · #1 ·
OK-I finally have the RC running. I have gotten the truck completely rewired and I still have a problem with two things.

1) I am having a tough time getting the brakes bleed. I had them pumped up and firm once but now they are spongey and the brake pedal goes all the way to the floor. Could I have air trap in the master cylinder. I replace all the brakes lines and wheel cylinders. I did not bench bleed it-I never removed the master cylinder. Do you have to have the truck running to bleed them(power brakes)?

2)I do not have a wiring diagram for the windshield wipers. It has 5-6 terminals on it and I do not have any of the old wiring harness. All I want to do is flip a switch to turn them on. Which terminal is ground and which is for 12 volts?

Thanks, Don
 

·
Registered
Joined
·
2,818 Posts
if you have taken the lines off the master at all i would bench bleed the master. i had the same problem with my PW UNTIL i bench bled it and no no problems. as for the wireing mayby CHUMP (aka einstien) has the diagram.
 
1 - 2 of 2 Posts
Top