Dodge RamCharger Central banner

Edelbrock Performer Pkg

8235 Views 23 Replies 15 Participants Last post by  kellerbj78
Months ago, my Son and I determined my '85 RC 360 block was overly tired. We bought an Edelbrock Performer Pkg from PartsAmerica web-site (SummitRacing is cheaper!), inc cam, intake, HD valve springs, timing set and a newly reman shorty was purchased on which we soon commenced construction.

NOTE: I had my ol' heads inspected, however, both were cracked. I ordered new ones from the same large SoCal reman which came back unworkable with the new HD springs. (Beware: RC heads have "rotator valves"). It took some time to obtain new rotator heads with the HD springs installed. The new roller timing chain is one King Kong couldn't bend. I have a rebuilt, stock Quadrajet on the new intake.

However, I'm not that pleased with end results. Performance is a whole package from stem to stern. The cam has 3 settings, I feel we mistakenly set the mid one. Likely, should have selected lower rpm torque one(?) and, someday later not sooner, may take all that frontal stuff off, again, to re-set.

With BFG 33s' and stock rear-end, Big Blu wants to get up and go at about 70+mph which is cause for several short-comings: Ain't no way this ol' stagecoach has the suspension, brakes, etc.. to safely match that speed in heavy SoCal Fwy traffic. Secondly, an ol' RC above 75-80mph is much like pushing a barn door. Let's face it, the aerodynamics are like a big ol' 747 trying to stay at 400mph in a 300mph headwind. Lastly, because of heavier lead-foot action, mpg is down significantly.

So, dot yur Ayes' and cross yur tees' on this rebuild jazz.....
Not bad overall costs though. I still have an MSD 6-A ign box standing by, along with some Hedmans (illegal in CA). I need to find matching MSD distributor to finalize that end, along with my current problem of replacing shorted out wiring from alternator to coil/distrib.

I'd like to hear from others who've done an Edelbrock. Performer Pkg rebuild on a 318 or 360. Frankly, I'd go with a slightly wilder cam and a LOW rear-end. Hey, the stock 360 is a bullet-proof, hi-torque, lo-rev deal. Not unlike an old over-size (bore vs. stroke) VW engine out of the distant past.
See less See more
1 - 1 of 24 Posts
I did that same setup 12 yrs ago on my 78 powerwagon, it worked fairly well but not real impressive, I went to a hughes 1019 AL and it seemed much better, they said I would not need headers with this cam and you don't, but I had some super comp hookers ordered and put them on anyway, and did it ever come alive with those on there, it was actually fun to drive! Just make sure whover puts the springs on, also cuts the guides down because stock guides will not allow over about .450 lift I think it is. Dan
One more thing, the performer is a 318 manifold, you have to at least gasket match the ports because they are the small 318 size, I had a few hours into mine but worth it.
1 - 1 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.