Dodge RamCharger Central banner
1 - 3 of 3 Posts

·
Registered
Joined
·
187 Posts
Discussion Starter · #1 ·
Will the drive plates (for lack of a better term) from the late seventies full time Dana 60 front axle fit in place of the selectro hubs on the early eighties Dana 60? I may possibly do a Dana 44 to Dana 60 swap on my '77 W200, and would of course retain my full time setup. Does anyone here have these plates to sell? Thanks in advance.
 

·
Super Moderator
Joined
·
29,558 Posts
Drive flange is the correct term, and yes the Selectro hubs swap back and forth with them with no issues.  They can be hard to find since many rock crawlers have been picking them up so they don't have to worry about breaking a hub.  There are some aftermarket ones available but most are not a sealed design and those that are, usually are for 35 spline aftermarket stub shafts.  Naturally you could run the hubs and just keep them locked all the time.
 

·
Registered
Joined
·
29,309 Posts
what he said above and my drive plates aint for sale either in case l break a hub
 
1 - 3 of 3 Posts
Top