Dodge RamCharger Central banner
1 - 4 of 4 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
I recently replace the bearings on my 60. Looks like it got a little hot cause everything was all messed up. Well when I went to put the new ones on they wouldnt fit. Fells like the spindal is to bid for the bearing i it will not go on. Could the heat have done this? What should I do to fix it? Or should I just buy another one?
 

·
Founder
Joined
·
25,731 Posts
you are talking about the bearings in the hub? Make sure the parts store gave you the right bearings, I bet that is the problem. I have had a bearing fail and weld itself the spindle and it still didn't effect the spindle.
 

·
Premium Member
Joined
·
5,022 Posts
Buy Timken. Might try a light sanding of the spindle. Could be a little bit of "crud" on there. Doesn't take much.
 
1 - 4 of 4 Posts
Top