[legit]

swapped a leaky evap and for good measure the expansion valve and drier but cant get drier to seal? both sides smooth, tried different torques , even two gaskets...bet vice grips would work but shit. any tips aside from swapping long line? did not leak before and I already threw old drier one out so cant retry it to see if it still seals.

 

[johnnycashjunkie]

I would sand all surfaces smooth get new gaskets and rub a little compressor oil on them and re torque bolts while holding the receiver drier and the discharge line equal so they line up properly

 

[Jeffy45]

That and tighten the hell out of it.

 

[johnnycashjunkie]

I would pressurize with nitrogen and bubble test it is well