Dodge RamCharger Central banner
1 - 9 of 9 Posts

·
Registered
Dodge 1973 W200
Joined
·
114 Posts
Discussion Starter · #1 ·
I decided to lift my truck and since you're suppose to replace the U bolts, I want to flip them, to where they are pointing up. I don't know how to figure out the diameter of an axle so that I can get the right ones. I have a D44 front and a D80 rear, which was given to me.(and no I am not mistaken. I know how to read Dana axles.)
Thank you in advance
Dodgercodger73
 

·
Registered
Joined
·
2,280 Posts
If you don't have access to calipers or C-clamps you can always use string-tape measure & calculate diameter from the circumference.

Bucky
 

·
Registered
Joined
·
2,605 Posts
Dodge Dana 80... I reckon 4" tube.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top