Dodge RamCharger Central banner
1 - 3 of 3 Posts

· Registered
83 Posts
Discussion Starter · #1 ·
I have a 1976 3/4 ton Dodge that was being used as a beater mud truck. Major rust issues. I'd like to use the 8 lug D44 front axle on the 78 Club cab I recently bought. Problem is that I hammered a big hole a little to hard while mudding in the 76 a couple years ago, and bent the frame on the drivers side where the shock mount is. Bumpstop is no longer lined up with the center of the spring and is lined up with inboard edge. What a good way to check if an axle housing is bent? Don't want to waste any time/effort on a bent axle...
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.