Dodge RamCharger Central banner
Cancel

360 pistons...

4470 Views 23 Replies 6 Participants Last post by  robo51, 
R
finaly building my 360 up...got some kieth black 10:.1 30 over pistons too go in. now will theses work ok if i use the 318 302 heads..... and does one use the stock pushrods from the 360 or 318? is anyone runnin these pistons here? how do ya like them?
Reply
Save
Like
1 - 1 of 24 Posts
7
robo51 said:
so back too my point is any one here useing the kb107s? at 10:1
Click to expand...
Yes I am using KB 107, but the CR is too high I had to retard the timing to less than 30 degrees to stop the ping.
What mixer are you going to use? I want to use propane, but do not know where to start.
Reply
Save
Like
1 - 1 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Dodge RamCharger Central
RamchargerCentral.Com is a Dodge truck community built by a vast number of experienced owners. Whatever you're thinking about doing from routine maintenance to full-on restoration, odds are somebody around here already has. Originally focused on the Ram Charger / Trail Duster, our members own, drive and wrench on Mopars from the 40s to the current day. It's not what you buy, it's what you build.
Full Forum Listing
Explore Our Forums
Vehicle Help Open Discussions Technical Discussion Ramchargers, Traildusters, Durangos and other SUVs Rams, Power Wagons, D/W 50s, Dakotas and other tru
Top