Dodge RamCharger Central banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi.... Would anyone tell me how to setup the heavy duty front spindle hub bearings on a 1995 3500.
thank you,
 

·
Premium Member
Joined
·
5,548 Posts
If it is 4wd. the 3 bolts that hold the bearing on are torqued to 125 ft lbs. The axle shaft nut is torqued to 175 ft lbs.

For 2 wd spin rotor in forward direction while tightening the spindle nut to about 20 ft-lbs to seat bearings. Loosen the nut 1/4 turn then using your hand, tighten nut till its snug. Don't use any tools to snug the nut down.
 
1 - 2 of 2 Posts
Top