Dodge RamCharger Central banner
1 - 1 of 1 Posts

·
Registered
Joined
·
52 Posts
Discussion Starter · #1 ·
i got an 84 318 motor, and its bored .40 over, and with a cam in it, and stock heads, i believe....i have no idea what type of cam is in it, and was wondering how to tell? and can i run my throttle body and intake on it with a cam?

Also, to finish off this build, what can i do with it on a BUDGET, for a few more horsepower? besides putting a new gasket set on it....and im hoping NOT to spend more than $500-$600 from here on out, but i can if need to.... its going in a W150 4x4 with a 4 speed....

And what is a good clutch for a pulling truck or mud truck? Centerforce dual friction or any other ideas?
 
1 - 1 of 1 Posts
Top