Dodge RamCharger Central banner
1 - 11 of 11 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter · #1 ·
can any one tell me if the input gear from a ford np205 will fit a 205 out of a dodge thank for the help
 

·
Registered
Joined
·
6,581 Posts
ford has 31 spline input
ford and dodge 1-ton 205's have 32 spline input

other than this it depends on what transmission you're trying to match it up with.
 

·
Registered
Joined
·
1,663 Posts
Dodge 205 have 23 spline male input shafts on all T-cases but the Cummins 5spd which is 29 spline male input, Ford and GM 205s use female input shafts with the wrong spline count for a Dodge.
 

·
Registered
Joined
·
38 Posts
Discussion Starter · #4 ·
im swaping in a cummins with a ford zf trany and want to use a 205 so i need to swap out input gears or run a chevy 205 with a ford input gear thanks
 

·
Registered
Joined
·
1,303 Posts
jdfrmnt said:
ok so thats that i need the big brng gm more money more money
Or get your current case bored to accept the larger bearing.
 

·
Registered
Joined
·
1,303 Posts
jdfrmnt said:
do you know if the dodge 205 can be bored out that much
Yes. Mine was a Dodge NP 205 and I had it bored to accept the Chevy female input shaft when I installed my doubler. My brother also bored a Chevy one out to put behind a TH 400 trans.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top